Myco Powered LLC

10/22/2026

Keep your best genetics without burning through plates. Each slant holds 10ml of enriched MEA in a purpose-built tube with a dual-position cap (vented during colonization, sealed for storage), and properly stored slants stay viable 6+ months.

Shop:

Professional culture tubes for long-term genetics preservation. Each slant contains 10ml of our enriched MEA formula in purpose-built tubes with dual-position caps for proper gas exchange management. Made fresh to order, individually sealed, and ready for immediate use in your culture library. Perfe...

10/19/2026

Tip of the Week: Most grain spawn failures start with water, not spores. After hydrating, grains should look plump but feel dry on the surface. If there's water pooling at the bottom of the bag or lots of split kernels, you're past field capacity and inviting bacteria. Let the grain sit in a colander for 30 to 60 minutes so the surface moisture steams off and drains before you bag and sterilize.

www.mycopowered.com

10/15/2026

Micropore tape lifts, gets soggy, and needs replacing every run. These 0.3 micron hydrophobic PTFE filters go on before sterilization and stay put through the cycle, sized at 20mm over a standard 1/4 inch port with 32 per sheet.

Shop:

10/12/2026

Tip of the Week: Test your liquid culture before it touches grain. Pull a few drops with a sterile syringe and put them on an agar plate, then give it 3 to 5 days. Clean, even mycelium means the jar is ready to use. Bacterial slime or off-color growth means you just saved a whole batch of spawn.

www.mycopowered.com

10/08/2026

Hand-poured fresh to order and guaranteed sterile, not pulled from months-old warehouse stock. One peptone-enhanced MEA formula handles isolation, cloning, and liquid culture work, with parafilm strips included and free shipping on every order.

Shop:

Made fresh the day you order, never pulled from a shelf. Hand-poured by one working mycologist, guaranteed sterile, and backed by a 0.27% contamination rate across 750+ plates. One honest formula for every species you grow.

10/05/2026

Tip of the Week: When transferring on agar, cut from the leading edge. The outermost ring of growth is the youngest, most vigorous mycelium and the farthest from anything that landed near your original inoculation point. Take a small triangle (about 5mm per side) right at the margin to keep blade contact to a minimum, and sterilize your scalpel then let it cool for a few seconds before cutting so you don't kill what you're moving.

www.mycopowered.com

10/01/2026

One pre-measured packet makes a 600ml jar of liquid culture for about a dollar. The lean three-ingredient formula feeds mycelium without feeding contamination, and there's nothing to weigh: add water, sterilize, and go. Built for restocking after a starter kit or keeping a culture library topped up.

Shop:

Skip the finished kit. Each pre-measured packet makes a full quart of clean liquid culture for about a dollar, with a lean three-ingredient formula I use in my own lab. No scale, no guesswork, no contamination-feeding filler.

09/29/2026

Tip of the Week:
Just harvested? Set your mushrooms gill-side up in a sunny window for about 20 minutes before you cook them. That's enough for the ergosterol-to-vitamin-D2 conversion to happen, with no change to flavor or texture. Just a nutritional bump for free.

09/25/2026

Building out a culture library or isolating a strain? Our Isolation Agar Plates use a nutrient-free formula so you can see exactly what you're working with before it ever touches a nutrient plate.


Shop:

09/22/2026

Tip of the Week:
Mushrooms don't need light to grow, but they do need it to know when to fruit. Blue-spectrum light (daylight or cool-white bulbs around 6500K) is the signal most species read as "time to pin." Aim for 12–16 hours of soft, diffuse light during fruiting, not direct intense exposure.